Re: Careful (Re: Timeout Settings)

Thread View: a2i.lists.netblazer-users

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Carlos Rimola Thu, 07 May 1998 00:00

#58

Author: Carlos Rimola
Date: Thu, 07 May 1998 00:00

31 lines
1690 bytes

At 02:05 AM 5/7/98 +0200, Stephen R. van den Berg wrote:
>Stuart Pierce wrote:
>>Configure>Mica>nodata-timeout {for all mica lines} 0
>
>Careful here.  Up until release 3.3p7, setting the nodata-timeout
>to 0 did *NOT* work as documented.  
>
>Has this been fixed in the latest granite code?  Carlos?  Anyone?

I am not sure that it has.  I just did a quick review of the most recent
statement of code for Portware 2.2.30 and the closest thing I found was a
fix that "adjusted connection timeouts".  Of course, there is one way to
find out..

Note that the portware (the firmware running on the modem card) is/was
under complete control of Cisco and only their developers had access to the
code needed to fix this type of problem.

>
>Also, one other thing, the country code setting for the Mica modems...
...
>Has this been fixed in the latest granite code too?

Same answer.  I do see some indications in the statement of code that would
lead me to believe that the country code is now more meaningful.

If you do try it, let us know the results..

Carlos Rimola
(ex NetBlazer Development)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads