🚀 go-pugleaf

Ok, I believe I've tried absolutely everything I can think of to get this upgrade from cs2 to cs3 to work.

Hardware: Dual 2ghz g5 Xserve, 3gb ram
Software: 10.5.6 Server Unlimited

The machine runs a bunch of services, including OD, NAT and AFP, and currently VC2, as it has for many years without trouble. I absolutely cannot install VC3 though.

I've tried:
Installing.
Uninstalling using the installer, then installing.
Using Disk Utility to repair permissions, then installing.
Installing, failing to install, then trying to "repair and reinstall" components using the installer.
Using CS3Clean on level 2, then installing.
Using CS3Clean on level 3, then installing.
Turning off the firewall, then installing.
Turning off VC2, then installing.

The only thing I couldn't try was installing in Safe Mode, as the machine got caught in an infinite loop when trying to boot into it. Could be indicative of something else.

Other problems that I found and eliminated while working on this:
Apparently there are some services that were enabled in 10.4 that, after upgrading to 10.5 (like I did on this machine) can remain enabled, but not work, and not present a real interface to show that it is running. One of these was the webobjects/jboss server, which was constantly trying to startup, but even after resolving this it still hasn't worked. Any advice?