🚀 go-pugleaf

The Master Page Tools plugin from Silicon Prairie software <http://www.siliconprairiesoftware.com/Products.html> handles blank pages very nicely and works on FrameMaker 8.x. It's only $10 and might meet your requirements.

The span pages functionality applies only to the first paragraph in the span. In your case, the anchoring paragraph for the table is only there on the first page of the table (despite appearances).

For your situation, perhaps you could assign a paragraph to mark the end of the table. If you set its "space below" property to some large value, like 999 pts, the following content will appear on the next page. Then, you set the "table anchor" � to use the landscape pages, but set it to "Until Changed". Then set the "end of table" � to use the landscape pages, but set it to "Single". Then you should find that your master pages are assigned correctly.

This is slightly clunky but it works well (at least for me).

Jon