🚀 go-pugleaf

Roel--

The problem is in the way that InDesign determines which page "owns" the rectangle. When you tell a page to add a rectangle, its left edge is at 0. This means that half of its stroke *touches* the left-hand page of the spread. To InDesign, that means that the rectangle is owned by that page, and that any measurements are based on that page.

To avoid this problem, always perform a slight relative move after you tell a page to add a graphic item:



Set myImg = myPage.Rectangles.Add 
Rem Move has two parameters, MoveTo and MoveBy. 
Rem (Sadly, MoveTo, the first parameter, is currently broken 
Rem for PageItems in all languages other than AppleScript.) 
Rem Use a comma to omit the MoveTo parameter: 
myImg.Move , Array("1p", "1p") 
myImg.GeometricBounds = Array(mtop, mleft, mbottom, mright)

Does that make sense?

Thanks,

Ole