🚀 go-pugleaf

I configured on a 2500 AUX, use a cisco roll over cable connect to a Cisco
modular adapter (i.e. similar to the 9pin console connector but usually
25pin and modem is written on it instead of terminal)

config something similar to this I think, this is my config for dialing up
my ISP via async modem.

interface ethernet0
 ip address 10.0.0.1 255.255.255.0
 ip nat inside
interface Async1 (do a show line to check async no)
 no ip address
 ip nat outside
 encapsulation ppp
 no ip mroute-cache
 keepalive 1
 dialer in-band
 dialer pool-member 20
 async mode dedicated
interface dialer 0
 ip address negotiated
 ip nat outside
 encapsulation ppp
 no ip route-cache
 no ip mroute-cache
 keepalive 1
 dialer pool 20
 dialer remote-name <my isp>
 dialer idle-timeout 36000
 dialer string <tel no>
 dialer-group 1
 compress mppc
 no cdp enable
 ppp authentication pap chap
 ppp chap hostname <username>
 ppp chap password 0 <password>
 ppp pap sent-username <username> password 0 <password>
!
ip nat inside source list 100 interface Dialer2 overload
!
access-list 100 permit ip any any
dialer-list 1 protocol ip permit
!
line 1
 no exec
 exec-timeout 15 0
 script dialer dialout
 modem InOut
 transport preferred none
 transport input all
 stopbits 1
 speed 115000
 flowcontrol hardware





"FD" <f.drogt@sze.nl> wrote in message
news:3cc6a219$0$225$4d4ebb8e@read.news.nl.uu.net...
> Hello,
>
> Does anyone kwown of it's possible to connect a analog modem to a
Cisco3662
> RJ45 AUX port and dailin to route data to the internal network?
>
> So yes, what is the pin configuration of this cable (RJ45 -- DB9).
>
> Freddy
>
>
>
>