🚀 go-pugleaf

On Mon, 29 Jun 1998 16:40:07 GMT, kev@dircon.co.uk (Kev) wrote:

>Hi Folks.
>
>Any1 know if there is a standard V.90 aT command set (which will work
>with Lucent / USR / and Rockwell ) for things like:
>
>Turning off V.90
>Setting a minimum and maximum speed
>etc, etc.

No.  The modems use different command sets.
>
>I have tried all of the commands at the back of my USR Message Plus
>V.90 and found the codes (and those given by AT$) to be totally
>ineffectual, in fact just plain wrong!.  

They work fine here.  S32.5=1 disables X2; S32.6=1 disables V.90


>So far as it goes S32.0=1 seems to turn off V.90 on my modem (given
>after 45mins to USR support).....but will it work for all V.90 modems?
>Like the +MS codes do for (most) flex modems.

S32.0 (according to my manual) controls V.8 Call Indicate.

The Courier uses a different register for the same features, and the
Rockwell and Lucent modems are different again.


Rick (remove X from e-mail address)