🚀 go-pugleaf

Did you put the jumper back to "normal" position ?  : )
Next time try doing the "manual method" of setting
IRQ's thru the PCI/PnP BIOS screen. You can lock
down the PCI slots IRQ's and also tell mobo what ISA
IRQ's you are going to use with non-PnP devices.

Zenith@my-dejanews.com wrote:

>  Hi Jack. If u were careful in not static shocking your computer, & moved the
> jumpers carefully... then there's not much to worry about. However, it is
> possible that u could of accidently touched something else. So u may want to
> recheck things such as: making sure chips are intact, no lose cables & nything
> else which may not always be apparent-> maybe just a little but light wiggle.
> Good luck.
>
> - Meshes
>
> In article <uFuz1.3109$T03.9999798@news20.bellglobal.com>,
>   "Jack" <jcuivert@hotmail.com> wrote:
> > I tried to reset my bios because of IRQ conflicts (I'm an amateur) by
> > switching jumper for battery to clear settings.  Computer only turns on LED,
> > fan and nothing else (no cd eject, no screen messages, no reset).  Did I
> > accidentally short my computer?  Any advice would be appreciated.
> > Board: TX97 - LE with P233
> >
> > Jack
> >
> >
>
> -----== Posted via Deja News, The Leader in Internet Discussion ==-----
> http://www.dejanews.com/rg_mkgrp.xp   Create Your Own Free Member Forum