🚀 go-pugleaf

Thanks for the reply. Have had a look at Lucents website but couldn't see
anything, shall try an e-mail to their "support". The ISP were going to use
Telnet to configure (Before realising they didn't know how to) I also have a
console cable to connect in the rear of the box.
The ISP did inform that it did not need a firmware upgrade!?

Tommy

"kony" <kingofnewyork@my-deja.com> wrote in message
news:3af7ebd2.12427618@news.earthlink.net...
> On Tue, 8 May 2001 10:43:42 +0100, "Tommy" <bouyaka(REMOVE)@nme.com>
> wrote:
>
> >Hi
> >
> >I have a Lucent Portmaster office router - model No: OR-HS which was
> >supplied by our ISP when setting up our leased line. I'd like to set this
up
> >to use NAT, the ISP says this can be done with this router but they don't
> >know how to do it despite them supplying it two years a go.
> >They can help, by selling me a new Cisco.!!!
> >
> >Does anyone have any information or pointers to a website!? for a generic
> >configuration file for this  Lucent router?
> >Thank in advance for any help/info with this.
> >
> >Regards
> >
> >Tommy
> >
> >
> >
>
> Have you tried Lucent?
>
> What are the "access points" for it?  A configuration panel on the
> front, HTTP,  Telnet, etc?  Unless this router has removable media
> capability, the only possibilities are configuration menus, or a
> firmware upgrade (consult manual).
>
>
> Dave