🚀 go-pugleaf

Thanks everyone for the replies.

Dick, do you know the settings now and how did you get them?  Also how
do you reset the cable modem?


>On Tue, 26 Nov 2002 22:36:10 GMT, Dick Huddleston <news@dontspamstratplan.com> wrote:

>Anon <one_american@bigfoot.com> wrote in 
>news:6dt7uucdj6kfts09al56e5ec68ftf43bnn@4ax.com:
>
>> From Katy,  Texas, what speeds can I expect to get from TimeWarner
>> cable using Earthlink?  
>> 
>> Also any advice I might need to tell the installer before he drills
>> thru my brick wall to place jack opposite the drill hole  (about 2
>> feet above ground) ?   Will they plug the hole with the proper
>> caulking and about how far down do they bury the cable?
>
>I had a good experience with my installers; they installed new cable, 
>Interestingly enough, they used a gasoline edger to dig the trench, so it 
>must not be deeper than 3 - 4".
>
>They did a very neat job running the cable along the top of the outside 
>wall. They drilled the hole where I told them (near the old phone wire 
>entrance) and caulked it well.
>
>Once inside, they ran the cable to the computer, installed the modem and 
>took off. The only gripe I might have is that they told me absolutely 
>nothing about what to do in case of problems, how to reset the modem, where 
>to call (Earthlink was a little huffy the one time I had to call, said to 
>contact TW).  I think if I had been left a set of instructions and 
>settings, I would have been completely satisfied.
>
>My d/l speeds approach 2 Mb and I don't know up speeds but they are plenty 
>fast. I live in the Williamsburg Settlement, in Katy just W. of Mason on 
>Colonial Parkway.
>
>Very happy with the service. BTW I use Earthlink instead of RR.
>
>Dick