10BaseT on 8600

Thread View: alt.irc.channel.macintosh

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Rob lIndsay Wed, 01 Dec 1999 00:00

Author: Rob lIndsay
Date: Wed, 01 Dec 1999 00:00

12 lines
1334 bytes

After upgrading from OS 8.5.1 to 8.6 my 8600 machines don't see the network
(G3's are OK). Currently the following workaround get them on the wire.

Open the AppleTalk control panel, select either modem or printer, save this
selection. Then open AppleTalk control panel again, this time select
Ethernet and wait for the 'Setup' 'Current zone to appear. Select the zone
then all is OK.

Has anyone struck this before and has a fix ??

Regards,
Rob

Re: 10BaseT on 8600

Author: Elvis Presley
Date: Tue, 07 Dec 1999 00:00

20 lines
1618 bytes

In article <823eg0$84t$1@panther.rmplc.co.uk>, Rob lIndsay
<r.lindsay@citylit.ac.uk> wrote:

> After upgrading from OS 8.5.1 to 8.6 my 8600 machines don't see the network
> (G3's are OK). Currently the following workaround get them on the wire.
> 
> Open the AppleTalk control panel, select either modem or printer, save this
> selection. Then open AppleTalk control panel again, this time select
> Ethernet and wait for the 'Setup' 'Current zone to appear. Select the zone
> then all is OK.
> 
> Has anyone struck this before and has a fix ??
> 
> Regards,
> Rob


Zap P-RAM (Command-Option-P-R while restarting) and all will be well.

  - Elvis

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads