🚀 go-pugleaf

Hi,

Was is the OS ?   NT or Win9x ?

If you connect 2 PC with RJ45 connector, you must use a HUB.

You can connect directly with BNC connector and one terminator (50ohm)
at each PC.

On Win9x use:
- NetBEUI protocole for LAN,
- Share Files/Printers

and share directories or your Hard Disk.

Are you a static IP for each PC on Internet ?

Regards,

Adrien
=====
Duncan Pole a �crit dans le message <87ke4c$v59$2@news7.svr.pol.co.uk>...
>Help ! I am stuck.
>
>I have two computers and I have connected them together by means of an rj45
>1metre cable.  A PCI ethernet card ieee 802.3 10base2 and 10baseT at one
>end,  and an ISA 3com etherlinkIII at the other end.
>
>I cannot get one computer to recognise the other.  What am I doing wrong?
>Is there any diagnostics can I run to try and solve the problem?
>
>Could it be hardware or software?  In control panel >system says they are
>both working properly. BUT the Isa 3com slot card says that "the resources
>this device is using  do not match any of its known configurations.  To
>assign resources manually for this device - set config manually.  NO
>CONFLICTS" - Could that be something to do with the problem?
>
>Do I have to change from my automatically registering IP address? (i.e.
have
>a static IP address)
>
>I have set up the network configuration (probably wrong), and the computers
>have been put in the same workgroup.
>
>I am ICQ no. 20429729 if you want to help online, or I would be extremely
>grateful for any help and advice.
>
>
>Cheers
>
>
>Duncan
>
>From Glasgow,UK