🚀 go-pugleaf

Hi!

I tried using the Dial-up Configuration Wizard in Red Hat Linux 7.2, but
that couldnt detect a modem.

Here's the report geenrated by scanPCI that says the modem is detected.

./scanPCI

The ltmodem drivers will FAIL to support currently known
winmodems with chipsets produced by:
      Conexant, Motorola, US Robotics, IBM, PCTel and Intel.
The Lucent AMR Soft modem is NOT supported.
Among Xircom modems some are supported, and these will be
    reported out during this test.
PCMCIA card modems are NOT accessed by this ./scanPCI utilty.
There are also ISA card Lucent modems which are not perceived.

Found modem: 11c1:0449
  This modem should be serviced by the ltmodem drivers.
The id are within the serviced ranges:
Name   vendor_id device id range
-----------------------------------------------
LUCENT  0x11c1  0x0440-0x045c
XIRCOM  0x115d  0x0000-0x000F
XIRCOM  0x115d  0x0440-0x045c
XIRCOM    0x115d          0x0010-0x03ff

Hope this helps, Bye.

I was also looking for info on installing a modem in command-line mode
rather than using the GUI.

-Nix


"chino" <chino2008@netscape.net> wrote in message
news:3D92FD94.5070902@netscape.net...
>
> Nix wrote:
>
> >Hi!
> >
> >The following site doesnt work anymore. Does anyone have any idea if the
> >file is mirrored anywhere?
> >
> >Lucent Winmodem driver for Red Hat Linux 7.2 kernel 2.4.7-10:
> >http://www.physcip.uni-stuttgart.de/heby/ltmodem
> >
> >-Nix
> >
> >
> >
> >
> There are 6 ftp sites for the 6.0 driver:
> driver name: ltmodem-6.00b7.tar.gz
>
> crydee.sai.msu.ru/zeus/Linux/notebook/
> fddisunsite.oit.unc.edu/pub/Linux/distributions/sourcemage/mirror/
> ftp://ftp.ibiblio.org/pub/Linux/distributions/sourcemage/mirror/
> ftp://ftp.oit.unc.edu/pub/Linux/distributions/sourcemage/mirror/
> ftp://metalab.unc.edu/pub/Linux/distributions/sourcemage/mirror/
> ftp://sunsite.unc.edu/pub/Linux/distributions/sourcemage/mirror/
>
> for previous versions, go to www.alltheweb.com, click on the ftp tab,
> and enter "ltmodem-"
>
> Note: this driver does not compile under gcc-3.x.
>
> luck
>
> ----------------------------
> "The software required windows 98 or better, so I installed linux"
>