🚀 go-pugleaf

In article <412@carroll1.UUCP> tkopp@carroll1.UUCP (Tom Kopp) writes:
>In article <9593@dasys1.UUCP> jzitt@dasys1.UUCP (Joe Zitt) asks: 
>>Is there a way to fake out a PC into talking to a different COM port?
>
>The dos assign command should work.  I've seen it used to tell something to
>send to COM1 everything that was supposed to go to lpt: so your mileage may
>vary.
>
>Basically, before you are going to use the modem, enter the following line:
>
>assign com1 = com2
>
>If this doesn't work, reverse the com1 and com2.  I haven't used the command
>for a long time, so....
>
>
>-- 
>tkopp@carroll1.cc.edu  or  uunet!marque!carroll1!tkopp
>Thomas J. Kopp @ Carroll College 3B2 - Waukesha, WI




I was having the same problem with a Zenith 248 that came with a funky 
adaptor that plugged into one of the bigger ports on back and had two ports
on the other side of it - I forget the specifics, but the effect was that
with the adaptor, the modem could not be plugged into COM1 but only COM2
which was on the back of the adaptor.

Anyway, I tried the DOS assign command and I believe that command is only
useful for assigning a COM port to an LPT port and possibly vice versa.  It
did not work assigning one COM port to another COM port.

I ended up yanking the stupid adaptor off of there.

-- 
    ---{john hayes}  Old Dominion University; Norfolk, Virginia USA
                     internet: aiko@cs.odu.edu
                     Home: (804) 622-8348     Work: (804) 460-2241 ext 134  

                      <++++++++++++++++++++++++++++++++++>
Are you a Have or a Have_Not?  Because if you're a Have_Not, you've probably
had it; whereas, if you're a Have, you've probably got it and are going to 
give it away at some point in the future!       --- The Clash
                      <++++++++++++++++++++++++++++++++++>