Article View: alt.msdos.programmer
Article #429HELP!!!!!!
From: DGH103
Date: Tue, 12 Dec 1989 05:15
Date: Tue, 12 Dec 1989 05:15
28 lines
1795 bytes
1795 bytes
Ok, I don't think that I explained myself very well the last time I posted this
message. I will try to explain it better this time. I have a Tandy 1400LT and
for some reason they have the modem and the com port attached together,
consequently I cannot use the modem and the mouse at the same time, but that's
not the problem. What I want to do is write a program that I will run when I am
going to use ProComm that will switch from the com port to the modem. I have
the service manual for the 1400 and I am a little lost. I will show how thw pag
e looks:
I/O Address Map
System Status Register
Address Bit Contents Control
(Write Register)
0FCH 2 Modem/RS-232C Switch 1/Modem,0/RS-232C
I guess I should explain that to switch between them now I have to use the
CTRL-ALT-INS key sequence to get to a setup menu then switch to the one I want.
Can anyone help me? Any help would really be appreciated!!
-------
*************************************************************************
* Darryl G. Hickson Penn State University *
* 761 Stratford Drive DGH103@PSUVM.BITNET *
* State College, PA 16801 *
* (814) 867-2234 *
*************************************************************************
Technical Details
Message-ID:
<89346.001555DGH103@PSUVM.BITNET>Path:
arc1-ca.pugleaf.net!utzoo!attcan!uunet!lll-winken!brutus.cs.uiuc.edu!psuvax1!psuvm!dgh103Show Full Headers
Complete Article Headers
Path: arc1-ca.pugleaf.net!utzoo!attcan!uunet!lll-winken!brutus.cs.uiuc.edu!psuvax1!psuvm!dgh103 From: DGH103@PSUVM.BITNET Newsgroups: alt.msdos.programmer,comp.sys.tandy,comp.sys.ibm.pc Subject: HELP!!!!!! Message-ID: <89346.001555DGH103@PSUVM.BITNET> Date: 12 Dec 89 05:15:55 GMT Organization: Penn State University Lines: 28