🚀 go-pugleaf

Hiya,

As the subject line says my USB mouse isn't getting any joy.

Logitech USB mouse.
Kernel 2.2.99-pre5
Abit BP6 motherboard with 2 x 366mhz celeron's

This is the output from "dmesg" with the relevant section about the mouse.
(So I guess it technically does pick it up)

After boot, there is no /dev/usb section and /proc/usb is a empty directory
; I'm guessing because of the "not recognized" line.

It says pretty much identically the same thing for my HP 5300C scanner. (but
I'll worry about that later).

Any ideas? I'm stuck in windows until I can get my mouse working for X :(

<!--StartFragment-->hub.c: portstatus 301, change 1, Low Speed
hub.c: portstatus 303, change 0, Low Speed
usb.c: USB new device connect, assigned device number 2
usb.c: kmalloc IF cbfd2540, numif 1
usb.c: skipped 1 class/vendor specific interface descriptors
usb.c: new device strings: Mfr=1, Product=2, SerialNumber=0
usb.c: USB device number 2 default language ID 0x409
Manufacturer: Logitech
Product: N48
usb.c: unhandled interfaces on device
usb.c: This device is not recognized by any installed USB driver.
  Length              = 18
  DescriptorType      = 01
  USB version         = 1.00
  Vendor:Product      = 046d:c001
  MaxPacketSize0      = 8
  NumConfigurations   = 1
  Device version      = 4.01
  Device Class:SubClass:Protocol = 00:00:00
    Per-interface classes
Configuration:
  bLength             =    9
  bDescriptorType     =   02
  wTotalLength        = 0022
  bNumInterfaces      =   01
  bConfigurationValue =   01
  iConfiguration      =   00
  bmAttributes        =   a0
  MaxPower            =   26mA

  Interface: 0
  Alternate Setting:  0
    bLength             =    9
    bDescriptorType     =   04
    bInterfaceNumber    =   00
    bAlternateSetting   =   00
    bNumEndpoints       =   01
    bInterface Class:SubClass:Protocol =   03:01:02
    iInterface          =   00
    Endpoint:
      bLength             =    7
      bDescriptorType     =   05
      bEndpointAddress    =   81 (in)
      bmAttributes        =   03 (Interrupt)
      wMaxPacketSize      = 0008
      bInterval           =   0a
hub.c: port 2 connection change
hub.c: portstatus 101, change 1, High Speed