🚀 go-pugleaf

Yesterday, Charles Fultz wrote:

>The following message is a courtesy copy of an article
>that has been posted to alt.os.linux.slackware,3dfx.glide.linux,alt.games.quake3,comp.os.linux.misc as well.
>
>Philip Willoughby <pgw99@doc.ic.ac.uk> writes:
>
>> Today, Charles Fultz wrote:
>
>> >Here is the output of glxinfo:
>> >display: :0.0  screen:0
>> >direct rendering: No
>>
>>                    ^^
>> that means it is using software GL... Chack the kernel module is loaded and
>> that DRI is enabled in your XF86Config, and that you have read and write
>> access in the DRI mode command.
>
>Here is the output from dmesg concering DRM:
>Linux agpgart interface v0.99 (c) Jeff Hartmann
>agpgart: Maximum main memory to use for agp memory: 322M
>agpgart: no supported devices found.
>[drm] Initialized tdfx 1.0.0 20000928 on minor 63
>
>I don't have any AGP cards, so the complaint from agpgart should be
>fine.  Is this good enough for the kernel level?

Probably.  Are you using the drm from the kernel or from the DRI tree?  The
one in the DRI tree is the best one to use, especially if you are using the
DRI X server.  Which X server are you using?

>Also, when I start X here is the output concerning DRI/DRM:
<snip>
>(II) TDFX(0): direct rendering enabled

This means that it has loaded and enabled the DRI... So your kernel part is
probably correct.

>Here is the DRI section from my XF86Config:
>Section "DRI"
>    Mode  0666
>EndSection

This should be OK.

>And here is the output of me running quake3 with the command:
>/usr/local/games/quake3/quake3.x86 +set r_smp 1

Try /usr/local/games/quake3/quake3.x86 +set r_smp 0 +set r_gldriver
/usr/X11R6/lib/libGL.so

Regards,

Philip Willoughby

--
echo bzidd@nfo.ho.co.se | tr "bizndfohces" "pwgd9ociaku"