🚀 go-pugleaf

TJ Miles wrote:
> 
> Kevin,
> (or anyone who knows for that matter)
>   I've recently started to experience problems upon booting up my
> approximately 3 yr. old Zeos 486-100 w/Martin motherboard. To make a
> long story short, the cause is that the info in CMOS is getting reset
> to default settings, rather than what I need them to be setup with, so
> I have had to go into setup and reset them to get the system to boot
> properly. Apparently, the system battery is going and the info is
> getting lost (correct?). If this is the cause, could you tell me what
> battery I need to get to replace the one on my system -- size/type,
> etc. as I'd like to go out and get it beforehand and not have to tear
> it apart and go into the case more than once. Anything else I should
> know regarding this little operation??



On the motherboard that you have, there is a coin cell battery near the
keyboard connector.  However, this has been spot-welded into place.  But
behind the battery there is a four pin connector labeled BATT for
connection of an external battery.  You can connect a battery pack here. 
You can get these packs at most any computer oriented store.

Kevin
-- 
Zeos Technical Support      | Any Opinions  | ZEOS International
support@zeos.com       INET |   expressed   | A Division of Micron 
Electronics
uunet!zeos.com!support UUCP |    herein     | 1301 Industrial Blvd N.E.
612-362-1207           FAX  |  are my own   | Minneapolis, MN 55413