ICS2002 sound chip

Thread View: alt.sys.pc-clone.zeos

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by Tom Cross Tue, 21 Feb 1995 21:59

#68

Author: Tom Cross
Date: Tue, 21 Feb 1995 21:59

30 lines
1988 bytes

When I originally received my Pantra 75, it had the drivers installed for 
Windows for the audio chip.  However, since I had to re-partition the 
drive, I had to re-install them.

I've got WAVEDEC.DRV, WAVEDEC.DSP, and VWAVEDEC.386 in \WINDOWS\SYSTEM, 
and I put the device line and drivers line in my SYSTEM.INI as described.

However, when I start Windows, it says:

I/O address 330 was specified, but 240 was detected and selected.
Interupt 5 was specified, but interrupt 9 was detected and selected.
DMA channel 1 was specified, but is not available.  DMA channel 6 was 
selected instead.

Then it gives me a nice blank screen with an hourglass in the middle as 
goes into la-la land.

I've tried setting the CMOS to other variables, but the only two that let 
me boot are disabled, and DMA 1 IRQ 5.

I've got a Pantera with a 75Mhz Pentium, 24MB RAM, the AMD SCSI chip, 1GB 
SCSI drive, and the ATAPI IDE CD-ROM.

If anyone can help, I'd greatly appreciate it.

--
Tom Cross             Voice: 612-253-1020    FAX: 612-253-6956
System Administrator                  E-mail: tomc@kendeco.com
Kendeco Industrial Supply               Info: info@kendeco.com

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads