Help

Thread View: alt.uu.math.misc

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Smuggins Wed, 29 Mar 2000 00:00

#121

Author: Smuggins
Date: Wed, 29 Mar 2000 00:00

3 lines
1155 bytes

I need to make a cone from flat sheet.
Can anyone tell me the formula for the top and bottom radii.
Smuggins.

Re: Help

#122

Author: Robert Harrison
Date: Thu, 30 Mar 2000 00:00

18 lines
1573 bytes

I'm not sure what you mean by top and bottom radii?  A cone has a point at
the one end.

To make a cone, draw a circle with any radius and cut it out.  Cut along any
two radii to remove a pie piece shaped sector.  This can then be shaped into
a cone.

Is that all you needed?  Or do you need more.

Bob

"Smuggins" <smuggins@lineone.net> wrote in message
news:8btnnl$mo5$1@supernews.com...
> I need to make a cone from flat sheet.
> Can anyone tell me the formula for the top and bottom radii.
> Smuggins.
>
>

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads