🚀 go-pugleaf

If you want to have success at changing interrupts, you must do it in safe
mode.
This frees up interrupts, so you have something to change them to.
Once you take them off of automatic and assign one, it should not change
back.

This could cause other conflicts, if you pick the wrong interrupts.



--
Bob Noble
Home of PC-Newbie list
http://www.sonic.net/bnoble

Dries Aendekerk <Dries.Aendekerk@advalvas.be> wrote in message
news:7ohe7c$d5c$1@trex.antw.online.be...
> Hello,
>
> I have the following problem:
> On my new computer i have an ISDN-card of Asuscom (ISDNLink) installed,
and
> a HP Scanjet 5200C
> (USB-connection)
> The scanner 'or' the isdn-card don't work: when i install the isdn-card,
> everything works fine, but when i also install the scanner, the system
> hangs. When i remove my isdn-card (or scanner), everyting is back alright.
> That means both devices can't work together on te same system.
> I just formatted my hard-drive again, so the Windows98 I installed today,
is
> not yet fucked up.
> ;-)
>
> The problem is that my ISDN-card and USB Root hub are always on the same
> IRQ.
> (first IRQ9, when i disable it, they take both IRQ11, etc...)
>
> When i contacted the HP Helpdesk, they told me to make sure the IRQ of the
> USB-port should be on a different IRQ than de ISDN-card.
>
> I always thougt it would be no problem an usb port and another
> pluy-and-play-device on the same IRQ.
> But they told me is could give problems with the HP Scanjet 5200C.
>
> I know i can connect this scanner on the parallel port, but i just want
the
> usb-connection.
>
>
> Does anyone knows a solution: how to force some devices to go to another
> IRQ, or does somebody has a better idea?
>
> I hope somebody can help me, because i'm out of idea's.
>
>
> Greetz;
>
> Dries Aendekerk
>
>