DMA Mode 2

Thread View: aus.computers.cdrom

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by X-Ray-Wa Wed, 28 Jul 2004 08:32

#47

Author: X-Ray-Wa
Date: Wed, 28 Jul 2004 08:32

12 lines
850 bytes

G'day

I have the GSA 4120B DVD Burner
It works Great.
I check the Bios and the DMA is set to DMA Mode 2
Right Setting
But
In Withdows XP It doesn't setup as DMA Mode 2 but has
DMA If Available "NOT Applicable"
I tried Updating / Removing drivers but with no luck

Any Info would be gratefully Accepted

Re: DMA Mode 2

#49

Author: Dee
Date: Fri, 30 Jul 2004 22:05

23 lines
1453 bytes

In article <2mp6l5FplqpeU1@uni-berlin.de>, X-Ray@ask.com.au says...
> G'day
> 
> I have the GSA 4120B DVD Burner
> It works Great.
> I check the Bios and the DMA is set to DMA Mode 2
> Right Setting
> But
> In Withdows XP It doesn't setup as DMA Mode 2 but has
> DMA If Available "NOT Applicable"
> I tried Updating / Removing drivers but with no luck
> 
> Any Info would be gratefully Accepted 
> 
you could try the following.

disconnect any other drive on the same controller, could be causing 
probs. then see what you get.

or

try uninstalling the channel from the IDE controller and restarting and 
see if winblows gets it right that time. (worked for me before)

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads