🚀 go-pugleaf

Hi to all.

I have a problem with my SCSI-2 CD-ROM and CD-R.
Ok the problem is that when i install linux from the cd-rom it crush
sometime on the installation, anyway after few attempts i did install
linux, but then the real problem happens. When the LILU boot up it is
detecting my SCSI controller card which is ADAPTEC AIC-7850 PCI, so
after he detect the controller card it is looking for my cd-rom's. So
far so good it is displaying the the cd-r's and then it is crushing no
message error nothing the computer is restarting !!!! ( sometime i get
�������� all over the screen and then restarts ) ??

Some info on my cd-rom:
Sony CD-ROM CDU625
MATSHITA CD-R CW-7502

My connection to the cd-rom's and the jumpers at the back are:
The fires devise on the SCSI cable is my CD-ROM ( test mode OFF,
prevent/allow ON, term OFF, ID select is set to ID5, parity ON )
The second devise on my SCSI cable is my CD-R ( term power ON,
terminator ON, parity ON, ID selector is set to ID6 )

Ps: The strange think is that i was installing about 2 months ago the
same linux on the same computer and i didn't have all these problems !!!
The only hardware i added was a voodoo2.

THANKS to you all for you priceless TIME.

With Regards
Gonzo