🚀 go-pugleaf

I'm not familiar with RedHat so I can't give the exact solution. You can
check the gateway setting in your Redhat and make sure it is not pointing
to any address. In another word, in your init files, you should not add
something like

      /sbin/route add default gw 192.168.0.1 netmask 0.0.0.0 metric 1

Note : according to your routing table all of your IP packet are gateway-ed
to 192.168.0.1 as the result of the above command.

Good Luck
Kadar

Todd A Norbury wrote:

> Gday all. Well, after finally nailing a few hardware related problems, I
> have got my Linux machine going.
> It is working fine across my LAN. I can FTP & Telnet to the Linux box. I
> think SAMBA is even running, it must
> do that as a default. My problem is still it wont connect to the net.
> Below are all my config files. If there are more I need to post, let me
> know.
>  Also, net-start wont run.
> This is what happens when i try and run net-start.
>
> [root@ozzy bin]# net-start
> bash: /usr/local/bin/net-start: No such file or directory
> [root@ozzy bin]# /usr/local/bin/net-start
> bash: /usr/local/bin/net-start: No such file or directory
>
> Any clues on that?
>
> Config Files.
> -------------
>
> Red Hat Linux release 4.1 (Vanderbilt)
> Kernel 2.0.27 on an i586
>
> [root@ozzy /root]# uname -a
> Linux ozzy 2.0.27 #1 Sat Dec 21 23:44:11 EST 1996 i586
>
> Whilst logged on.
> -----------------
>
> [root@ozzy bin]# ifconfig
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
>           UP BROADCAST LOOPBACK RUNNING  MTU:3584  Metric:1
>           RX packets:129 errors:0 dropped:0 overruns:0
>           TX packets:129 errors:0 dropped:0 overruns:0
>
> eth0      Link encap:10Mbps Ethernet  HWaddr 00:00:E8:3A:17:0A
>           inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:1311 errors:0 dropped:0 overruns:0
>           TX packets:1576 errors:0 dropped:0 overruns:0
>           Interrupt:9 Base address:0x300
>
> ppp0      Link encap:Point-Point Protocol
>           inet addr:203.2.228.248  P-t-P:203.15.68.20
> Mask:255.255.255.0
>           UP POINTOPOINT RUNNING  MTU:1500  Metric:1
>           RX packets:9 errors:1 dropped:1 overruns:0
>           TX packets:10 errors:0 dropped:0 overruns:0
>
> [root@ozzy bin]# route -n
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> 203.15.68.20    0.0.0.0         255.255.255.255 UH    0      0        0
> ppp0
> 192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        4
> eth0
> 127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        3
> lo
> 0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0       11
> eth0
>
> After Logging off.
> ------------------
>
> [root@ozzy bin]# route -n
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> 192.168.0.0     0.0.0.0         255.255.255.0   U     0      0        5
> eth0
> 127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        3
> lo
> 0.0.0.0         192.168.0.1     0.0.0.0         UG    0      0       11
> eth0
>
> [root@ozzy bin]# ifconfig
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Bcast:127.255.255.255  Mask:255.0.0.0
>           UP BROADCAST LOOPBACK RUNNING  MTU:3584  Metric:1
>           RX packets:130 errors:0 dropped:0 overruns:0
>           TX packets:130 errors:0 dropped:0 overruns:0
>
> eth0      Link encap:10Mbps Ethernet  HWaddr 00:00:E8:3A:17:0A
>           inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:1550 errors:0 dropped:0 overruns:0
>           TX packets:1711 errors:0 dropped:0 overruns:0
>           Interrupt:9 Base address:0x300
>
> Here are my config files.
>
> [root@ozzy bin]# cat /etc/hosts
> 127.0.0.1               localhost localhost.localdomain
> 192.168.0.1             ozzy
> 192.168.0.2             hercules
> 192.168.0.3             arnie
>
> [root@ozzy bin]# cat /etc/resolv.conf
> search zeta.org.au kralizec.net.au .
> nameserver 203.15.68.3
> nameserver 203.15.68.18
>
> [root@ozzy bin]# cat /etc/kralizec.chat
> ABORT BUSY
> ABORT 'NO CARRIER'
> '' AT&F%E2
> OK ATDT0298371933
> CONNECT '\c'
> ogin: todd
> assword: ****
> ts> ppp
> 'Your IP' '\c'
>
> [root@ozzy ppp]# cat options
> lock
>
> Any help, greatly appreciated.
> --
>   Todd A Norbury
>   mailto : nospam.todd@zeta.org.au
>   URL : http:/www.zeta.org.au/~todd
> Please remove nospam from email address.