🚀 go-pugleaf

Hello All,



I have a message at boot that I do not understand. The system complains
that it can't locate module char-major-10. Whats this?

I am using Slackware 2.0.29 kernel - I have changed the orriginal kernel
and used "make config" to get the kernel I think I want,  followed by
"make zImage" and a "make modules" followed by "make modules_install". I
have SCSI and IDE.

Everything seems to behave as expected - but something (perhaps) is
amis.

I am not sure what a char-major-10 is and thus I do not understand what
to look for.

Any help and advice will be appreciated.

Thanks,
Col.

Below is a snippet of the boot up.

/etc/rc.d/rc.S: Testing filesystem status: Read-only file system
Parallelizing fsck version 1.06 (7-Oct-96)
/dev/sda3: clean, 29278/130560 files, 357852/522240 blocks
Remounting root device with read-write enabled.
/dev/hda1 on /dosc type vfat (rw)
UMSDOS Beta 0.6 (compatibility level 0.4, fast msdos)
/dev/hda5 on /dosd type umsdos (rw)
/dev/hda6 on /dose type vfat (rw)
/dev/hda7 on /dosf type vfat (rw)
/dev/sda1 on /dosg type vfat (rw)
none on /proc type proc (rw)
Jun 16 03:53:52 modprobe: Can't locate module char-major-10
Updating module dependencies for Linux 2.0.29:
CSLIP: code copyright 1989 Regents of the University of California
SLIP: version 0.8.4-NET3.019-NEWTTY-MODULAR (dynamic channels, max=256)
(6 bit encapsulation enabled).
SLIP linefill/keepalive option.
PPP: version 2.2.0 (dynamic channel allocation)
PPP Dynamic channel allocation code copyright 1995 Caldera, Inc.
PPP line discipline registered.
PPP BSD Compression module registered
Configuring serial ports....done.
cua0 at 0x03f8 (irq = 4) is a 16550A
cua1 at 0x02f8 (irq = 3) is a 16550A (spd_vhi)