🚀 go-pugleaf

Thanks for the info.. however I do suspect it is someting even more sinister...
The computer has been running perfectly with it's current setup 
(minus any VLB videocard)..

Only when I insert a VLB video card do I get interference...Ido have a VLB 
drive controller which does not seem to have probs by it'self.
The problem only goes away when
when I change back to having a standard 512K EISA video card....

I will  get a rundown of my entire system soon, and repost this assistance 
request...

It's a really fidley problem.. mind you everyting still works ok, no crashes, 
etc, just can't transfer files via Floppy 
(but then again everyone uses FTP right?)

rachel@virago.org.au (Rachel Polanskis) writes:

>In article <5f6hls$pdf@news.usq.edu.au>,
>	maxwella@usq.edu.au (Andrew Maxwell) writes:
>> Hi there,
>> I have a problem that is really bugging me..Althought it is not
>> directly a Linux problem, it is stopping me from using parts of
>> Linux....
>> 
>> I have a VLB motherboard and everytime I put in a VLB videocard, it
>> stuffs up my VLB Floppy Drive Controller such that I cannot read/write
>> or do anything with floppies....Can anyone offer any assistance...
>> 
>> (I suspect that this Slot Mastering stuff is mucking me up)

>You need to be careful here.
>Some VLB boards don't follow specs properly and tell you they are capable
>of 33mhz when they are not.

>I had a similar problem to yours when I tried to increase the bus speed.

>I started getting kernel panics and the like whenever I accessed the
>floppy drive. When I reduced the bus speed back to normal the problem went
>away.

>Check you motherboard manual to see if you have the bus speed setup
>correctly.


>rachel
>                 defghijklmnopqrstuvwxyz:  What? No ABC?
>--
>Rachel Polanskis                 Kingswood, Greater Western Sydney, Australia 
>grove@zeta.org.au                http://www.zeta.org.au/~grove/grove.html
>r.polanskis@nepean.uws.edu.au    http://www.nepean.uws.edu.au/ccd/
>                Witty comment revoked due to funding cuts