🚀 go-pugleaf

Adam Frey (adam@eden.apana.org.au) wrote:
: In <4q3l1u$5od@chuckie.apana.org.au> braddock@labrador.apana.org.au (Reg Braddock) writes:

: >I have an incredibly irritating problem - the printing on each
: >successive page is 10mm further down the page than the last page.  The
: >result is that, after only a few pages, the output spews across
: >sheets.

[cut]

: I suffered with this problem for about a year and a half. It was present
: under OS/2, Linux and FreeBSD. The simple answer is that neither the 10e
: nor the 200 modes in ghostscript are properly compatible with the 330.

: If there is a solution other than using a different printer, I never found
: it.

 Check the config files for ghostscript looking for the a4 paper size
 definition.... when you find it you'll see it describes the size
 in some wierd measurement... now check exactly what a a4 page *should*
 be and what your printer is printing... and scale the number and
 create a new page size definition.

 Should work.

 Peter

-- 
 Peter Childs  ---  http://www.imforei.apana.org.au/~pjchilds
  The internet is full, please try again in half an hour...