🚀 go-pugleaf

plraskis@ix.netcom.com (Peter L. Raskis ) writes:

>Help?

>I'm trying to install Linux but can't get my Mitsumi double speed CD
>recognized.  The CD player is connected to the IDE connector on a
>SoundBlaster compatible (ACER) card.

>The sound card is located at Port Address 220H, IRQ Channel 10, DMA
>Channel 1.

>The CD (Mitsumi FX Series (ATAPI IDE)) (Jumper set as slave) is at Port
>Address 170H, IRQ Channel 15.

	Set the jumper to master.

>I've tried just about every Boot disk image.  I would like to have the
>CD recognized from the Boot disk so I can install from the CD.

>Any help solving this puzzle is greatly appreciated.

I had to install from hard-drive and then reconfigure ide.c to get it to 
recognise my quad mitsumi....but thats just the way i chose to do it...
but definately jumper it as master...

cyah..
===========================================================================
= Anthony John Green                   =GCS/GO H- au->++ a- v- C++ ULS++  =
= E-mail : jag80@wumpus.cc.uow.edu.au  =L++++ N++ W--- M+ R tv D+++ e+ U* =
= University of Wollongong, Australia  =n+ w+ P+ d? H- S++:++ !g !P       =
===========================================================================