Thread View: aus.computers.logic-prog
2 messages
2 total messages
Started by Zak
Tue, 21 Oct 2003 13:41
bitstream compatibility
Author: Zak
Date: Tue, 21 Oct 2003 13:41
Date: Tue, 21 Oct 2003 13:41
16 lines
1777 bytes
1777 bytes
Am I correct in thinking that a design lab that was simuated and implemented onto a demo board with Xilinx Foundation 3.1, can have its bitstream used with another version such as Xilinx Foundation 4.2i? Using the same demo board (with same Spartan FPGA XCS10 on digilab board XLA5) that was used for initial design with Foundation 3.1 - I want to demonstrate this design again on the same board, this time using Foundation 4.2i... I am assuming I can just copy the dot bit file from my initital implementation, and paste it in the later 4.2i version of Foundation and send it straight down to the board again without having do any importations of schematics or code from the earlier version. Any advice on this issue would be most welcome.. Thanks Z
Re: bitstream compatibility
Author: MM
Date: Tue, 21 Oct 2003 15:49
Date: Tue, 21 Oct 2003 15:49
11 lines
1356 bytes
1356 bytes
"Zak" <chippa11@hotmail.com> wrote in message news:3f9537c8$0$21651$afc38c87@news.optusnet.com.au... > Am I correct in thinking that a design lab that was simuated and implemented > onto a demo board with Xilinx Foundation 3.1, can have its bitstream used > with another version such as Xilinx Foundation 4.2i? The *.bit file can be used with any version of the tools that supports the device it was originally generated for. /Mikhail
Thread Navigation
This is a paginated view of messages in the thread with full content displayed inline.
Messages are displayed in chronological order, with the original post highlighted in green.
Use pagination controls to navigate through all messages in large threads.
Back to All Threads