🚀 go-pugleaf

In <3q26lm$es1@eden.adam.com.au>, mikel@eve.adam.com.au (mikel lindsaar) writes:
>Hi,
>
>I have Sytos plus tape backup for OS/2.  It's quite a nice programme to 
>use... but... it sucks when writing to the tape as OS/2 basically stops 
>at the end of each tape run.
>
>Is there a patch/fix/updated driver for Sytos Plus to overcome this?

I also use Sytos Plus (version 1.38) with a Colorado Powertape SCSI QIC
drive but I have not had and problems at all. The version I had was a special 
for the Colorado so perhaps you are right about the tape driver being the 
problem. I do not know what tape controller you are using but it is possible
that your DMA and IRQ setting are in conflict if you are using a non SCSI 
controller. I would check that first and then try for a new driver.
Good luck !

//----------------------------------------------------------------------------
// Wal Chenney
// Sydney, Australia
// email: <walch03@ibm.net>