🚀 go-pugleaf

I have a very short test routine in FORTRAN, which I am trying to use with
S+ on an SGI work station. After compilation (as per the book on S+) I try
to load it using say 

	dyn.load("test.o")

where S+ responds with messages about missing externals (these have to do 
with internal I/O of the test routine). I tried to use the command

	ld -r -d -o test1.o -lF77 -lI77 test.o

but this does not seem to have any effect, i.e. either the externals are not 
in these libraries, or this ld command does not have the desired effect.

Is there anyone out there who knows how to do this correctly?

------------------------------------------------------------------------------
Dr. Henry Granek                     |       e-mail: hxg@dar.csiro.au
Division of Atmospheric Research     |       or   granek@vax.dar.csiro.au
CSIRO                                |       Fax:     +61-3-586 7600
Private Bag No. 1                    |       Tel:     +61-3-586 7518
Mordialloc, 3195 Victoria            |       Telex:   AA34463
AUSTRALIA                            |
------------------------------------------------------------------------------