Hello are there anyone here that has knowledge of engineering pulsed high voltage electronics ?

Thread View: be.science.electronics

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by none Thu, 29 Oct 2009 10:47

#132

Author: none
Date: Thu, 29 Oct 2009 10:47

41 lines
2518 bytes

Hello are there anyone here that has "inside knowledge" of how a DIESEL 
FUEL INJECTOR DRIVER BOARD for:
Solenoid common rail injectors
Piezo common rail injectors
Pump injectors (Diesel)
  are engineered and wants to contribute to design a Diesel version of 
megasquirt ? ?


The design requirements are:
Up to 150VDC internal boost power supply
Up to 35A peak current / 20A hold current
* Buck - Booster / Injector Switch
* Piezo - Valve Switch
* Solenoid - Valve Switch
Operates from 6V to 48V battery

Circuit protection
o Internal power supply overload protection
o Internal power supply over-charge protection
o Module temperature protection
o Open circuit protection
o short circuit protection
GLOW PLUG DRIVER ( non I.D.I engines needs this )
* Current Sensing

* High-Side Switch

* Low-Side Switch

* Temperature Sensing


COMMON RAIL PUMP CONTROL/PUMP CONTROL
* Current Sensing
* Motor Switch

if you have the required skill and time, report to the Megasquirt forums 
ASAP!

http://www.ms3efi.com/forums/viewtopic.php?f=12&t=288

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads