Re: Anyone have good general purpose AR addressing Start & stop Macros

Thread View: bit.listserv.asm370

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by David P. de Jongh Mon, 02 Oct 2006 22:09

#154

Author: David P. de Jongh
Date: Mon, 02 Oct 2006 22:09

21 lines
2960 bytes

You don't need AR mode or BAKR to go from 24 to 31.  Is there something
specific you're trying to do?
Most assembler code will run as-is in AMODE(31), but there are some I/O
macros that need special treatment, and some assembler service macros that
must be replaced.  Take a look at the Assembler Services Guide.  Chapter 5
discusses 31-bit addressing and migration issues.  31-bit addressing is also
discussed in DFSMS Macro Instructions for Data Sets.
D de J

-----Original Message-----
From: IBM Mainframe Assembler List [mailto:ASSEMBLER-LIST@LISTSERV.UGA.EDU]
On Behalf Of John Mattson
Sent: Friday, September 29, 2006 11:39 AM
To: ASSEMBLER-LIST@LISTSERV.UGA.EDU
Subject: Anyone have good general purpose AR addressing Start & stop Macros

Wow, finally getting to upgrade those old assembler modules to 31 ANY. And
wow, has assembler changed in the last few years, and wow, am I rusty. So,
does anyone have some nice general purpose START and STOP macros for AR
Addressing, BAKR and all that?   Or maybe you can point me at a website
where  I can find such?  Thanks

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads