🚀 go-pugleaf

In article <D3HLyH.1E2@uuhare.rabbit.net> Dan@Frezza.Org (Dan Frezza) writes:
>From: Dan@Frezza.Org (Dan Frezza)
>Subject: Setup85.exe
>Date: Sat, 4 Feb 1995 17:59:04 GMT

>I have been having alot of trouble getting the link to work on my
>computer. I installed the setup85.exe from the Ti Archives, and check
>everthing, but the communications port on my com2 doesn't want to work.
>I verified the com2 port, that the link is working with my other
>"link85.exe" dos program and works perfectly. But in windows, it doesn't
>work at all. 

>Any suggestions?  I tried everthing I could, but via Windows, the com
>link won't receive or send.

>-- Dan Frezza

Have you gone into Control Panel's "Ports" applet to make sure that Windows 
knows how your com2: is configured? In Ports' "Advanced" settings is where you 
assign a given ports addresses, IRQs, et all...  You might look in there and 
make sure evrything matches.  And if setup85.exe is a DOS file (have to 
confess ignorance on this one--haven't really bother to get the program, so 
this is just general Windows stuff that pops to mind) than in its .PIF file 
you may try setting its Priorities to higher values to make sure it gets a 
bigger piece of time pie--this is a fairly common problem using DOS comm 
programs under Windows.

Good 

Matt Tuley
Physics Teacher
Arvada CO



                                                                 \
 MATT TULEY         ---()---()---()---()---()---()---()---()--- >===
tuley@csn.org                                                    /