ISO 9000-3 Clause 4.11 Control of inspection, measuring and test equipment

Thread View: bit.listserv.iso9000

2 messages

[T] Back to Threads [V] Tree View [G] Group Articles

2 total messages Started by Bob Dickie Sun, 30 May 1999 00:00

#185

Author: Bob Dickie
Date: Sun, 30 May 1999 00:00

14 lines
888 bytes

In the case that you state, a simple statement within the Quality 
Management System or Project Quality Plan, should state exactly what the 
situaton is :- Clause 4.11 Control of Inspection, measuring and test 
equipment is not applicable as there is no equipment which requires 
calibration.

In some cases it is better to make provision for equipment which may be 
purchased/used which will require calibration. Good future planning!

Hope this helps

Regards

Bob

Re: ISO 9000-3 Clause 4.11 Control of inspection, measuring and test equipment

#186

Author: rflinn
Date: Sun, 06 Jun 1999 00:00

33 lines
1799 bytes

I agree. Tell them you don't have a reequirement.  The second advice
sounds like a government inspector which I were at one time.  I used to
require people to discuss what they would do if they had a requirement
even if their business would never require it.  As I have aged, I may
have gained wisdom.  I just tell auditors that when I get the
requirement, I will decide what to do with it.

Dick Flinn
President, AQC

In article <MPG.11bbb702fac1b2a2989680@news.virgin.net>,
  r.dickie@virgin.net (Bob Dickie) wrote:
> In the case that you state, a simple statement within the Quality
> Management System or Project Quality Plan, should state exactly what
the
> situaton is :- Clause 4.11 Control of Inspection, measuring and test
> equipment is not applicable as there is no equipment which requires
> calibration.
>
> In some cases it is better to make provision for equipment which may
be
> purchased/used which will require calibration. Good future planning!
>
> Hope this helps
>
> Regards
>
> Bob
>

Sent via Deja.com http://www.deja.com/
Share what you know. Learn what you don't.

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads