🚀 go-pugleaf

Hello all,
  Just had a little question and was hoping someone might be able to help me
out.  How do you permanantly get rid of the Alphanumeric code inserted by
Xedit on some files?
   Depending on the FileType, Xedit inserts this code below, (The 1st 3 letters
of the file name and then the line #).
______________________________________________________________________________
Command ==> ______________________
00001 test line.  (Want to get rid of this Alphanumeric code ----->)  TES00010

_______________________________________________________________________________
Does anyone know what I should change in my PROFILE XEDIT file or if should  I
look there at all?   I've checked all the SET commands, but none of them
seem to be the cause of this code insertion.  It only happens to certain files
also,(i.e. PL/I, Assembler) which leads me to believe there is a setting  set
somewhere, But WHERE???!!    The lines only show up after I've saved my file
for the first.  The second time I bring up the same file into the editor the
lines appear because they've been inserted.  Any help or leads would be
would be greatly appreciated.  Thanks.

Victor Tewari
BITNET <TEWARI@NKI>

P.S.  Even if someone could tell me what exactly this code is called
      "officially" by Xedit, that would help also.  Thanks again.