🚀 go-pugleaf

Bob,
Thanks for the reply. I agree about changing the registery. It's something I
want to avoid.

I've tried to adjust my LED value to take into account the scroll size
setting, but that doesn't seem to work. I was able to work around the
problem by adding a trackbar and use the trackbar position to adjust the LED
value. Once I do that I can use the mouse wheel to adjust the LED value one
digit at a time. Since I don't need the trackbar I can hide that control.

Thanks,
Steve

"Bob Gonder" <notbg@notmindspring.invalid> wrote in message
news:669o419mj16l7qfa770upbrptaa97mgir7@4ax.com...
> Steve Fear wrote:
>
> >I'm stumped on how I can set the scrolling size property for the mouse
> >scroller.
>
> This sounds a bit like it might be a VCL question, which would be
> better asked in the  .vcl.components.using  group.
>
> If Adam's answer isn't what you were after, then...
>
> You might check the registry entry
> HKEY_CURRENT_USER\Control Panel\Desktop\WheelScrollLines
> to see what the setting is.
> I would advise against changing the value because changing user
> settings tends to anger users.
>
> >I want to use the mouse wheel to adjust a value in a LED control. Right
now
> >the code works fine except for the increments being set to the mouse
> >scrolling size.
>
> You might be able, though, to count the increase messages and divide
> by the scroll rate before changing the control. (Like change the
> control once every "WheelScrollLines" increases)
>
>