🚀 go-pugleaf

Dear Mike,

When i type this command line under dos prompt, it will show the message
"Fatal: File not found: 'Unit1.dcu'"
It seems can't compile out the *.dcu file if i specify the path. But after i
compile the application under delphi 5 program and not under dos command
line, it will success create the Unit1.dcu file. Then i try to type the
command line as below :

dcc32 c:\test1\project1.dpr

It will work. I think it is because the Unit1.dcu already exist under the
Test1 folder there. But i wonder is that anyway to do it instead of change
to the Test1 folder directory to type the dcc32 command if the *.dcu is not
there? Thanks for advice.

Regards,
Andy

"Mike Williams [TeamB]" <mlwilliams@gmail.com> wrote in message
news:Xns95AFEEA992BCBmikewteamb@207.105.83.66...
> On 28 Nov 2004, "Andy" <ccyew@gprotechnologies.com> wrote:
>
> >  Is that anyway to write the
> > commandline instead of change to the directory to type the dcc32
> > command?
> >
>
> That should work fine.  I usually use a DCC32.CFG file to specify unit
> paths.  What happens when you do just:
>
> dcc32 c:\test1\project1.dpr
>
> ??
>
> It seems to me that it should find units that are in the same directory
> as the project but I'd have to verify that to be sure.
>
> -- 
> -Mike (TeamB)
> Newsgroup guidelines:
> http://www.borland.com/newsgroups/guide.html
>