🚀 go-pugleaf

Hi,

One - you can find the URW fonts off of the Gimp page (gimp.org)

Two -
I was able to get jbuilder to install under linux (RH 6.1/KDE) using the 
JDK 1.2.2 by putting X in 32-bit mode (startx -- -bpp 32).  I then tested
to see if it would fire up, it did.  Then I tested it by starting x in 16 bit
mode, that was no good, it would not fire up.  But in 32 bit it works fine. 
I'm not sure why so if anyone has a clue as to why, I would be curious in
hearing your thoughts.

Three-
Performance on a K6-2-350/64 mb of ram/4mb riva 128 card - is really good. 
Good job!

Pat

On Fri, 10 Dec 1999, Michael Doherty wrote:
>And what/where are the URW fonts?
>
>Paolo Ciccone wrote:
>> 
>> Michael Doherty wrote:
>> >
>> > Hi all,
>> >
>> > Just installed JBuilder3 for linux, and it's great!
>> >
>> > However, the error below message apears when a program runs.
>> > Could someone let me know where the appropriate fonts can be found.
>> > My machine is an AMD k6-2 450Mhz w/128 MB ram.
>> 
>> Install the URW fonts.
>> --
>> Paolo Ciccone
>> JBuilder dev.team