🚀 go-pugleaf

Easy Fly 40 by Hangar 9. Partially assembled but never finished. The
wing halves and the tail wing are put together so it will not fit back
into the original box for shipping so anyone interested should
probably live in the southern California area or even somewhere
between Los Angeles and Phoenix because I travel to Phoenix weekly.
   Plane specs:
           Wing Span                         64-3/4 inches	
           Wing Area                          712-1/4 inch2
            Approx. Weight      	 4-3/4-5 1/2 lbs.
           Engine Reqmnts                 .40-.46 2-cycle
                                                      .40-.50 4-cycle
           True UltraCote covering
           Positive self-righting flight characteristics
           90% pre-built   (more than that now).
           Extensive hardware kit included
           Break away motor mount prevents engine
           damage during minor nose-overs
   The plane has everything that that came with it (instruction
manual, hardware, video tape showing how to fly it etc.......) and I
still have the box in good condition. I purchased extra "doodads" and
"thingymajiggers" from Hobby Shack that are still in the box like a 12
volt starter, a 12 volt battery w/charger, 4-way glo plug wrench,
extra control horns, big rubber bands, a propeller, glues, cables,
tubing, push rods, foam rubber and just the regular ods and ends that
go with the plane.   
   I also have an O.S. MAX .46LA  4 stroke engine w/muffler and glow
plug. This engine is still in the box and has never been started or
used. Very nice engine with a blue aluminum finish. The instruction
booklet and even the little decals are included. 
   Also, a "very nice" Hitec Flash 5 FM radio w/4 servos, an HFD-08RD
receiver. Still brand new and never been used.
 
                       Features and Specifications:
 
           4/5 channel Microprocessor design.
           2 model memory capabitity.
           In flight timer and alarm.
           Changeable from MODE II to MODE I stick configuration.
           Low battery warning signal for transmitter.
           End Point Adjustment for channels 1 through 4.
           Dual Rate switches for Aileron And Elevator.
           Exponential rates for channels 1 through 4.
           Trim Memory for channels 1 through 4.
           Trim Reset function (to factory defaults).
           3 preset mixing functions (AIL/RUD, ELEVON, V-TAIL).
           Master data reset function (to factory defaults).
           Channel 5 retract landing gear switch
           Trainer jack and switch.
           Power supply: 9.6 volt AA nicad pack, internal.
           Power consumption: 200 mA.
           SHEUWEEEEEE! 
   Everything listed above is still in excellent and/or new condition.
Everything needed to get ain the air is included ecxept maybe fuel and
a fuel pump. I have invested about $450.00 into this kit and will sell
it for half of that or less, maybe $250.00 or $200.00 depending on
what is involved as far as getting the kit to you. I do not want to
split the set up so it is all or nothing. This is a very good deal. 
   Please email me if interested and I will give you my phone #.
            Andy.Alexander@att.net