🚀 go-pugleaf

Hendric Stattmann <hendric@bluewin.ch> wrote:
> | tux:/dev # insmod sr_mod
> | insmod: sr_mod: no module by that name found

sr is the SCSI CD-ROM driver (to be able to access read-only CD-ROMs
on a SCSI or SCSI emulation adapter). 

Now, I have never used an IDE CD-Writer (only SCSI CD-Writers), and I
think that you need to install the SCSI-over-IDE emulation:

   modprobe ide-scsi
   modprobe scsi_mod
   modprobe sg

I don't think you need sr_mod (since you can read-only access the CD-ROM through
IDE already --- however maybe in SCSI emulation, this is required, ie you
can't use the old IDE mode, maybe ?)

Later in the CD-Writing-Howto:

  Now to the people with CD-writers for IDE/ATAPI.  As written in the
  previous chapter, you have to load the compatibility driver ide-scsi.
  But this driver can only access your CD-Writer, if no other driver has
  already done so. In other words, you have to tell the regular IDE
  driver to leave your CD-writer unrecognized, so the ide-scsi driver
  can grab it.

If your CD-ROM is the slave of the primary IDE channel:

         append="hdb=ide-scsi"

to your lilo.conf

(there are other ways to do it when your IDE CD-ROM driver is
 loaded as a module, see the FAQ)

From then your CD-writer is accessed like SCSI (/dev/sgX for writing,
/dev/scdX for reading).

> Ich bef�rchte, dass es wohl noch _sehr_ lange dauern wird, bis ich meine
> 1. CD unter Linux braten kann, aber vielleicht komme ich ja so schon mal ein
> St�ck weiter...

install cdrecord and type
   cdrecord -scanbus