🚀 go-pugleaf

Marc SCHAEFER wrote:
(...)
> >     |    Tekram DC310         = =               +--,,,,--,,,,--+
> 
> I have an old SYM53c810-based ASUS board too, on board there are
> either pluggable resistors, or a jumper (look in the manual). If not
> using the internal XOR the external bus (ie not both are terminated
> by a device) bus you need to terminate the board !

Tja, mein Board hat keine Jumpers. Dies heisst einen 2. Terminator
kaufen. OK. 
Im Manual steht :
  * Active SCSI bus termination.
  * Termination is required for both ends of a SCSI bus.
  * DC-310: Need to do nothing for the termination on the DC-310,
    since it's equipped a pair af Active Terminators on U1B & U2B.
    If it's Passive Terminators, which are resistor array, used on RP1,
    RP2,RP3, you'll need to remove them if the DC'310 is not located at 
    one end of the SCSI bus. White dot on the resistor array must point 
    to the small box while installes.
Hier stehts. Ich brauche an beiden Enden einen Terminator. Wie
unterscheiden
sich aktive und passive Termination ?  Hat die eine Termination einen 
Vorteil ? Gut, ich werd' einen 2. aktiven Terminator besorgen. Den 1.
hab'
ich ja schon. 

Cordiallement
Simon

-- 
--------------------------------------------------------------------
                                                      Simon Schmidig
                                              schmidi6@etus.unige.ch
PGP KeyID: 512/15974F7D FP: 0A8B 2D45 CA8F A407  6799 371F 3703 4B10