🚀 go-pugleaf

In article <32714F40.28A1@compuserve.com>,
	Stephane Freund <100617.3260@compuserve.com> writes:

> Does anybody access to compuserve with this option ?
> Because I can't access so. I did all what they sad, inclusive the script
> but it don't work.

I did once configure a PPP access to CompuServe for a UNIX pppd, the
expect strings where as follows. Perhaps if the software you use
on your proprietary plateform is flexible enough you can use the
information below to configure it correctly.

'' ATZ OK AT&O0DT012731028 CONNECT '^M' ame: CIS ID: 1000xx.xxxx/GO:PPPCONNECT ssword: password

The &O0 is to switch into V34 mode (not ISDN X.75) for the ZyXEL which
was used in that case. You can safely remove it. You have of course to
replace 1000xx.xxxx by your CompuServe ID, and password by your
password.

BTW: it does not seem to use CHAP/PAP as an authentification protocol,
and the initial link seems to be 7 bit.