🚀 go-pugleaf

harakka_j@salcjkl.salcom.fi writes:
: In article <.1.0@>, @ (Henrik Gudbrandsen) writes:
: > Our department are connected to a campus network and have access to mail/
: > news etc.  In addition we are using Lantastic for printersharing/
: > fileserver. (100+ users)
: > 
: > My question is: Is there a way to run both tcp/ip-based software (clarcson 
: 
: As far as I know, if you use Lantastic's own NetBIOS implemetation, you
: cant use anything else (using the same card) simultaneously.  On the
: other hand since Lantastic can be run over many other NetBIOS's, it's
: possible (at least in theory) to run some TCP/IP implementation. which
: supports NettBIOS on top of it and then run Lantastic on top of that
: NetBIOS. Off course, this eats up much more memory than plain Lantastic...
: 
: Disclaimer: I haven't done this (yet), only digged a little bit since
: I have similar needs...
: 
: 					- juha -
: 
: P.S. If somebody have any other possibility, I'm VERY interested...
: 
YES!!  there is a NETBIOS packet driver in the Clarkson collection
that will sit on top of LANtastic's Netbios and using ka9q as a
router will allow you to access TCP/IP hosts/networks. I have 
tested this and works quite well. Details are included in the
NB.NOT file with the netbios driver and gives config parameters
for ka9q.

Ian.