🚀 go-pugleaf

Alan,

What Dave wrote is very likely the case. The ethernet print server is yet
another reason that a cable modem should be a router and not a bridge -
unfortunately the cable industry think they loose control (= money) that
way. Unless you want to install more hardware, you should convince your
provider that they need to give you an extra IP address for your print
server. Request that you get it for free, even if they normally charge for
it. In this case you are not hooking up an extra PC (= extra user), so they
should give it to you for free.

Good luck,

--
http://www.Cable-Modems.Org/ is your cable modem reference guide.
Tutorial, Q&A, articles, home networks, security, photo gallery and more!

David Gibbs wrote in message <18QlOOA8+yZu9Re=o5JGhTX32svf@4ax.com>...
>Caveat: I'm not a networking or cable modem expert ... the following
>is just from my own experience.
>
>On Sun, 7 Nov 1999 12:05:36 -0600, "Alan Sadler"
><asadler@21stcentury.net> wrote:
>
>>The bad news is, that my printer stopped working.  It's an old HP3,
>>connected to a HP Jetdirect EX plus print server.  The printer is too far
>>for a printer cable, so I hooked it up through Ethernet.  It worked for
the
>>last 5 months without a hitch.  I didn't check it before the 21st century
>>installer left.  He did say that my IP is now Dynamic(DHCP) instead of the
>>static one on the old modem.  I understand the above, but not why the
>>Printer stopped working.  Any help would be appreciated.
>
>Sounds like your printer is no longer in the same network as your
>computer.  When you had a static IP you could setup the printer server
>to have a similar IP address as your computer... now the IP address is
>set by the DHCP server and is probably not in the same network as the
>printer.
>
>Assuming you are running windows... run the WINIPCFG program to see
>what IP address is assigned ... a wild guess is that the IP is in the
>24.x.x.x region (this is a standard address block for the cable
>industry).  Your printer is probably NOT in this area.
>
>A solution would be to put a 2nd NIC into your computer and hook the
>cable modem to that, so it will have it's own IP address assigned by
>DHCP ... and assign private IP's to original NIC, and plug that into
>the hub with your print server (and any other computers).  That also
>gives you the ability to make your cable modem attached computer act
>as a router (with appropriate software) so that all the computers in
>your network can access the internet via your one connection.
>
>david
>