LAT Bridging

Article View: comp.dcom.sys.cisco

Article #101

Back to comp.dcom.sys.cisco Previous Next

#101

From: John Wright
Date: Fri, 07 Aug 1992 14:54

39 lines
1458 bytes

DEC or IEEE depends on what other bridges you have on your net, If you
have newer bridges which use the IEEE spanning tree then use that if
you have older bridges which use the older DEC LANBridge 100 flavor spanning
tree then use that.

Your configuration file for IP routing, DECnet routing, and bridging
LAT for a two ethernet router would look something like this.


decnet routing 10.2
decnet node-type area
decnet max-address 1023

Interface Ethernet 0
ip address 131.108.2.1 255.255.255.0
decnet cost 3
bridge-group 1
bridge-group 1 input-type-list 201

Interface ethernet 1
ip address 131.108.4.1 255.255.255.0
decnet cost 3
bridge-group 1
bridge-group 1 input-type-list 201

bridge 1 protocol ieee

access-list 201 permit 0x6004 0x0000        ; Ethernet type of DEC LAT
access-list 201 deny   0x0000 0xffff        ; deny everything else

----
You may also wish to permit MOP (6001, & 6002), if any of your LAT
devices might boot across the cisco.

Regards,
John Wright
Customer Engineering
cisco Systems, Inc.

Technical Details

Message-ID: <9208071454.AA22113@last-call.cisco.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!gatech!usenet.ins.cwru.edu!agate!boulder!recnews

Show Full Headers

Complete Article Headers

Newsgroups: comp.dcom.sys.cisco
Path: arc1-ca.pugleaf.net!sparky!uunet!gatech!usenet.ins.cwru.edu!agate!boulder!recnews
From: John Wright <john@cisco.com>
Subject: LAT Bridging
In-Reply-To: Bill Lewandowski's message of Thu, 6 Aug 1992 22:44:40 GMT <wrl-060892152818@wdl133.wdl.loral.com>
Message-ID: <9208071454.AA22113@last-call.cisco.com>
Sender: news@colorado.edu
Date: 7 Aug 92 07:54:02 -0700
Lines: 39