🚀 go-pugleaf

We have installed 2 ISDN lines running the German 1TR6 standard.
On one end is a 4500 with an 8 port S0 card and on the other an
old 3000 with a single S0 interface.

When trying to connect both boxes give the same message as can be seen
at the end of this message. The config follows. Our partner is getting
pretty antsy so any help at all would be appreciated.

German Telekom say that both lines are Ok but we are not progressing.

gate.noddy.de>sh int b 0 1
BRI0: B-Channel 1 is down, line protocol is down 
  Hardware is BRI
  MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255
  Encapsulation HDLC, loopback not set, keepalive not set
  Last input never, output never, output hang never
  Last clearing of "show interface" counters never
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  Five minute input rate 0 bits/sec, 0 packets/sec
  Five minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 packets output, 0 bytes, 0 underruns
     0 output errors, 0 collisions, 158 interface resets, 0 restarts
     0 carrier transitions



gate.noddy.de>sh dial
BRI0 - dialer type = ISDN

Dial String      Successes   Failures    Last called   Last status
089997364             0       156        3d08      Failed
0 incoming call(s) have been screened.
BRI0: B-Channel 1 - dialer type = ISDN
Rotary group 0, priority = 0
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
BRI0: B-Channel 2 - dialer type = ISDN
Rotary group 0, priority = 0
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)



gate.noddy.de>en
Password: 
gate.noddy.de#wr t
###
Current configuration:
!
version 10.0
!
hostname gate.noddy.de
!
enable password x500sucks
!
ip accounting-threshold 2048
isdn switch-type basic-1tr6
!
interface Ethernet0
ip address 195.112.84.49 255.255.255.240
ip accounting
!
interface BRI0
ip address 195.112.84.46 255.255.255.240
ip accounting
no keepalive
dialer map ip 195.112.84.33 089997364
dialer-group 9
!
ip host GATE.BIGEARS.DE 195.112.84.33
ip route 0.0.0.0 0.0.0.0 195.112.84.33
access-list 101 permit ip 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255
dialer-list 9 list 101
!
line con 0
line aux 0
line vty 0 4
password x500sucks
login
!
end



gate.noddy.de#debug isdn e
ISDN events debugging is on
gate.noddy.de#term mon
gate.noddy.de#pi 195.112.84.33
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.112.84.33, timeout is 2 seconds:

ISDN Event: Call to 089997364 at 64 Kb/s
Activating ISDN line....
BRI 0: Can't bring up phys interface TX 0xFCFF030F643301FF len 8
BRI 0: Physical layer DOWN-DOWN (Probably Persistent Deact (T3 expiry)).
Success rate is 0 percent (0/5)

-- 
Iain Lea                                       RK SCN D, Siemens AG., Germany
iain@scn.de             <http://www.scn.de/~iain>            +49 911 978 3120