Re: rhott@nswc.navy.mil / MTU for Ethernet Interface

Article View: comp.dcom.sys.cisco

Article #208

Back to comp.dcom.sys.cisco Previous Next

#208

From: Gary Kunis
Date: Sun, 16 Aug 1992 19:37

15 lines
675 bytes

> Is it  possible to change the Ethernet MTU

Bob,

You can change the MTU.  Each interface has a default mtu size.
This value can be changed by the interface mtu subcommand.  An
example is:

interface ethernet 0
mtu 1024

There is a write-up of this in the 9.0 manual on page 7-12.

 -- Gary --

Technical Details

Message-ID: <9208161937.AA19106@ash.cisco.com>

Path: arc1-ca.pugleaf.net!sparky!uunet!cs.utexas.edu!qt.cs.utexas.edu!yale.edu!yale!gumby!destroyer!ncar!csn!boulder!recnews

Show Full Headers

Complete Article Headers

Newsgroups: comp.dcom.sys.cisco
Path: arc1-ca.pugleaf.net!sparky!uunet!cs.utexas.edu!qt.cs.utexas.edu!yale.edu!yale!gumby!destroyer!ncar!csn!boulder!recnews
From: Gary Kunis <gkunis@cisco.com>
Subject: Re: rhott@nswc.navy.mil / MTU for Ethernet Interface 
Message-ID: <9208161937.AA19106@ash.cisco.com>
Sender: news@colorado.edu
Date: 16 Aug 92 12:37:24 -0700
Lines: 15