Re: rhott@nswc.navy.mil / MTU for Ethernet Interface

Article View: comp.dcom.sys.cisco

Article #211

Back to comp.dcom.sys.cisco Previous Next

#211

From: The VolleyDog - E41
Date: Mon, 17 Aug 1992 15:00

27 lines
1480 bytes

In article <9208161937.AA19106@ash.cisco.com>, gkunis@cisco.com (Gary Kunis) writes:
|> 
|> > Is it  possible to change the Ethernet MTU
|> 
|> Bob,
|> 
|> You can change the MTU.  Each interface has a default mtu size.
|> This value can be changed by the interface mtu subcommand.  An
|> example is:
|> 
|> interface ethernet 0
|> mtu 1024
|> 
|> There is a write-up of this in the 9.0 manual on page 7-12.
|> 
|>  -- Gary --   
Gary,  Thanks for the info.  I should have mentioned that I am using
rev 8.2(4) of the software.  Is this mtu for the ethernet interface
new for 9.0?  I tried the command that you recommended, but it
appears to have been converted to the IP interface and not the Ethernet
interface.  :-(

Bob 
====================== #include <std/disclaimer.h> =========================
Bob Hott, NSWCDD, Networks Branch (Code E41) |"If man were not meant to play
Dahlgren, Virginia  22448   (703) 663 - 4447 | volleyball, why are there so
rhott@relay.nswc.navy.mil                    | many beaches?"  - Bob Hott -

Technical Details

Message-ID: <1992Aug17.150005.12942@relay.nswc.navy.mil>

Path: arc1-ca.pugleaf.net!sparky!uunet!dtix!relay!nswc.navy.mil!rhott

References: <9208161937.AA19106@ash.cisco.com>

Show Full Headers

Complete Article Headers

Path: arc1-ca.pugleaf.net!sparky!uunet!dtix!relay!nswc.navy.mil!rhott
From: rhott@nswc.navy.mil (The VolleyDog - E41)
Newsgroups: comp.dcom.sys.cisco
Subject: Re: rhott@nswc.navy.mil / MTU for Ethernet Interface
Message-ID: <1992Aug17.150005.12942@relay.nswc.navy.mil>
Date: 17 Aug 92 15:00:05 GMT
References: <9208161937.AA19106@ash.cisco.com>
Sender: news@relay.nswc.navy.mil
Organization: NAVAL SURFACE WARFARE CENTER
Lines: 27

Reply to Parent Message