🚀 go-pugleaf

The situation is that I currently have 8 modems attached to an STS-10x
terminal server, acting as a bank of callin modems.  I have each of
them configured for 'modem ri-is-cd'.  Reading the manual I have,
it claims that if I set them for 'modem inout', they modems can
be used for both calling in and dialing out.

I have tried this and it works half way.  The modems still accept
in coming calls without any problem.  I can %telnet sts10x 4001
and get connected to a modem, but here comes the problem.
The modem appears to accept AT commands; it doesn't echo the commands
back but that is because I have set the modems not to (ATE0Q1).
The modems does dial the number and connect to the end modem, but
then I don't get anything back.  IE, any characters coming back
from the other end never appear in my window.

I was just curious as to whether other people have tried this and if
I'm overlooking something real stupid.  I plan on trying to dig up
an rs-232 analyzer and seeing what happens to the incoming characters,
but haven't gotten around to it yet.

As an aside, this version supports a limited slip version.  What is
the latest version of the ROM?  Does is support VJ header compression
on slip?  How about PPP?

Here is the configuration:
    sts10x> sh hard
    TS Software (STSX-S), Version 8.1(55)
    Copyright (c) 1986-1990 by cisco Systems, Inc.
    Compiled Wed 04-Jul-90 11:06
     
    System Bootstrap, Version 4.2(54)

Thanks for any info,

Clint Kaul				Work:  505-845-7557
Sandia National Labs, Div. 1421		Fax:   505-845-7442
PO Box 5800
Albuquerque, NM  87185			Email: ckaul@cs.sandia.gov
-- 
Clint Kaul				Work:  505-845-7557
Sandia National Labs, Div. 1421		Fax:   505-845-7442
PO Box 5800
Albuquerque, NM  87185			Email: ckaul@cs.sandia.gov