help with BOOTP load

Thread View: comp.dcom.sys.cisco

1 messages

[T] Back to Threads [V] Tree View [G] Group Articles

1 total messages Started by conni annable Tue, 10 Apr 1990 02:12

#391

Author: conni annable
Date: Tue, 10 Apr 1990 02:12

31 lines
1642 bytes

I am trying to get a terminal server to boot using bootp and tftp through a 
cisco router. The server boots fine when it is on the same ethernet as the 
load host. It also boots fine when it is on the other ethernet but is told 
the IP address of the load host - it ARPs for the host, the cisco answers 
'that's me' and tftp is then used for the load.

The router has been told it has a helper address for ethernet 2 - which is 
the load host residing on ethernet 0. This helper address appears in a show 
config, but not in a show interface ethernet 2. I mention this because the 
cisco documentation shows an example of a show interface that indicates a 
helper address - that example is for a serial interface however. Should I 
be able to see the helper address with show interface?

If I use debug packet-events, the cisco indicates:

BOOTP: opcode 1 from host 0.0.0.0 on Ethernet2, 0 secs, 0 hops

I have put my lanalyzer on that ethernet - the cisco never responds to the
server. 

Has anyone out there done this? Can you see what I am doing wrong?



conni         network manager

University of Texas Health Science Center at San Antonio
Internet:     annable@thorin.hscsa.utexas.edu
BITnet:       annable@uthscsa
THEnet:       shire::annable
Ma Bell:      (512) 567-2091

Thread Navigation

This is a paginated view of messages in the thread with full content displayed inline.

Messages are displayed in chronological order, with the original post highlighted in green.

Use pagination controls to navigate through all messages in large threads.

Back to All Threads